View Single Post
Old May 27th, 2018, 02:07 AM   #4
Stevbrdly
Tarry Hall
 
Join Date: May 2010
Posts: 329
Default

It sounds like you need to do a 3 wire measurement of the toe stop stem pitch diameter and find a tap that is a few thousandths over what the toe stop comes out to be.

Standard 3 wire measurements with .032 wire for 18tpi for 2A threads (this is a fairly standard for fitment between ID and OD threads)

Min: .6312 (this would be your GH1 tap, which should cut nominal)
Max .6357 (GH11 (this is considered oversize for this thread size))


Remember however, if the owner of the plate ever goes to use different toe stops, the threads may be tight or loose depending on the toe stop stem.


Hopefully this helps.
__________________
Tarry Hall Roller Rink Pro Shop Manager
Please visit our Facebook Page
www.facebook.com/TarryHallProShop
Stevbrdly is offline   Reply With Quote