View Single Post
Old August 27th, 2014, 10:23 AM   #40
ALBERT.PACO
Senior Member
 
Join Date: Oct 2010
Location: Valencia (Spain - Europe)
Posts: 118
Default

Quote:
Originally Posted by Armadillo View Post
I suspect that such "a zone without contact with the tire," resulting from this shallow groove cut in the hub near center, WILL be a problem, and will reduce the efficiency of the compression and rebound cycle of the urethane directly below that zone.

-Armadillo
Yes, You have reason and I think that the shallow groove could be a problem for the tire fitting.

I will leave this idea and I will make the hub based on the First V3 design.

Thanks for your suggestions.

Last edited by ALBERT.PACO; August 27th, 2014 at 11:12 AM. Reason: Update Info.
ALBERT.PACO is offline   Reply With Quote