Thread: Axle Help
View Single Post
Old November 17th, 2019, 11:19 AM   #13
Senior Member
fierocious1's Avatar
Join Date: Apr 2010
Location: Texas
Posts: 3,335

Originally Posted by rwsz View Post
fier 1 now that is talent and good machinery,,,,nice
Thanks. It takes a while to get it all planned out, then setup. I'm lucky enough to have 2 small mills, 1 dedicated to frames(DA45) only. Setup never gets torn down. But making frames on a manual mill takes lots of time.

The real talent is in making trucks, they are tough to do. Making plates is much easier.
fierocious1 is offline   Reply With Quote