View Single Post
Old April 5th, 2016, 09:44 PM   #6
Armadillo
Senior Member
 
Armadillo's Avatar
 
Join Date: Apr 2008
Location: Chicago, Near the Lake
Posts: 6,537
Default

Quote:
Originally Posted by Juice_ View Post
I have some yellow cushions, will switch those out.

In some ways it just feels counter-intuitive to use harder (i.e. slicker) wheels when all I'm already doing is sliding during my plows, no?

I will take the suggestion though and borrow some wheels from a friend and go skate around tonight to see how it feels.
Yes, I misread that OP, and harder will likely slide more.
If wheels are sliding without slowing you, then wheels obviously aren't gripping, and harder will likely grip less. Are there any grooves left in the 88A wheels? 88A wheels should not lose ALL all their plow stopping grip from just the plate swap. How many other wheel sets have you tried on the new plates?

Sometimes if the wheel contact patch is too large, the wheel can ride up on top of the floor's dirt/dust breaking grip. On a dusty floor, a firmer wheel with fresh grooves can often plow stop better than a soft wheel with no grooves.
The grooves accept the dirt and keep the urethane from being pried up off the floor by dirt/dust.

How dirty are the 88A wheels and how dirty/dusty is the is the floor?
Do 88A wheels slide out on turns too, with the Advantage plates, when you are going fast?
Dusty floors neutralize grip for both firm and soft wheels, especially when grooves are shallow or missing.

-Armadillo
__________________
Rollin' on AIR
Armadillo is offline   Reply With Quote