View Single Post
Old September 6th, 2019, 02:53 PM   #6
is skating again. WOOT!
chuckboucher's Avatar
Join Date: Aug 2006
Location: South Central, MA
Posts: 2,715

Originally Posted by BMW325TI View Post
Thanks mate, I have of these clamps. Will try out. Do you know how to get more heel wide. It seems this area is very stiff....
You could use a long nut with two bolts. Thread the bolts into both ends of the nut and tighten until the bolts fit inside the collar of the boot. Then loosen the bolts until enough pressure is had to fit the collar. Make sure to put some sort of padding on the bolt heads, so you don't damage the boot lining.

The type of nut looks like this:

Use a heat gun or an oven to get the heat required to make the carbon pliable.
Indoor Inline: Pinnacle Full Customs | Simmons SR110 4x110 | TLTF/Simmons | NMB
Outdoor Inline: Simmons Full Customs | Simmons SR110 4x110 | Junk Wheels | NMB
Quads: Reidell 911 | Roll-Line Mistral | Corey Super-Ds/JG Hubs | Bones Swiss
chuckboucher is offline   Reply With Quote