View Single Post
Old January 6th, 2017, 12:00 AM   #19
thesavo
Junior Member
 
Join Date: Dec 2016
Posts: 17
Default

I just rockered my twisters. I too had an issue getting the bearings out of the OEM wheels. The spacers are different than I'm used to. It was shot, smooth, sleeve instead of being stepped. My 3-way tool didn't seem to work. I used a small Slotted screwdriver to push one out. I nicked the side shield on them. Is that something that just flatten out as they are used?

Last edited by thesavo; January 6th, 2017 at 08:02 PM. Reason: typos
thesavo is offline   Reply With Quote