View Single Post
Old January 21st, 2016, 06:06 PM   #133
ALBERT.PACO
Senior Member
 
Join Date: Oct 2010
Location: Valencia (Spain - Europe)
Posts: 118
Default

Quote:
Originally Posted by Mort View Post
Inlines load up on a radial forces on bearings where quads load up on axial forces on them.

Unless your doing slalom moves where the weight is being leveraged of course. Holding a hard carving edge in speed skating is mostly radial loads, and even a slower leisurely quad skater is going to produce more axial loads.

Each can have bearings tailored to their type of forces for a little better operational efficiency, but it wouldnt make much of a difference in feel.

Ive been skating micro bearings for about 3 months now. 3 to 4 times a week, always hard. While they are not as strong as the standard 22mm bearings, they shouldn't have a problem unless you have a catastrophic hit to them on the axial plane in a quad skate. Say in deby someone stomps down to get around you and smashes their big toestop onto your sideways facing wheel... or someone falls on your foot and lands their weight on a truck. That could break one if a smaller player hit square or with a large player just dropping weight onto it. A rare event though.

Of course ypur "bones" still "roll as good" if you have kept them maintained. Clean oil or grease is essential to preventing wear and polishing raceways.

I stopped running spacers on my quads to do 2 things, try to pull my arius axles loose, and to fully test the durability of these smaller bearings. Im not the largest person on skates, but I put some hard session time on them.

Eventually id like to get some of his hubs, just to have a set for my own comparisons, but im pretty convinced hubs with changeable tires arent as good as bonded urethane wheels.
Thanks for your explanation about the bearings.

When I compete in speed, I have competed with interchangeable wheels and not interchangeable wheels and Deano, Vanguard fanjet or Labeda Turbo wheels had very good performance.

The only fault I put to him was that the aluminum hub were heavier but were fine performance. They are two different concepts of wheels.

I hope soon you get a set of my hubs for to test on your skates.
ALBERT.PACO is offline   Reply With Quote