View Single Post
Old August 26th, 2014, 02:06 PM   #39
Mort
Sk8 Ninja
 
Join Date: Aug 2012
Location: Huntington Wv
Posts: 3,424
Default

WJCIV! lol good idea. But as dillo was fast to point out already that doing so would make the spacer rotate with the wheel.

Now since your idea is a good one though here's what I propose. Machine the hub and do not bore anything but an 8mm hole in the center if possible. When you cut the bearing seat width you can cut the spacer at the same time. Then when the width is set you can cut the area out between the spacer and the bearing seat shoulder. Presto the exact spacer for each hub.
k
I don't like aluminum for spacers though. Cutting your own spacers without a lathe, thats the trouble with them. How could one cut them to size
__________________
Home rink: Roll-A-Rama in Huntington Wv.
"Focus on form and speed is a byproduct, focus on speed and falling is a byproduct." - Matguy
Mort is offline   Reply With Quote