View Single Post
Old October 5th, 2016, 12:16 AM   #13
Senior Member
Armadillo's Avatar
Join Date: Apr 2008
Location: Chicago, Near the Lake
Posts: 5,719

Remanufacturing a plate that has failed because it was poorly engineered from the get go by the the manufacturer does not make a lot of sense to me.
#1 → It could fail again, and you could be severely injured, but have no recourse with suing the manufacturer for the cost of your injuries.
#2 → Unless the company/person repairing the plate will assume liability for the repairs, why do them?
#3 → The repair will look rather ugly unless you spend enough to match what buying a single new plate (hopefully at some discount) would cost.
#4 → You should let Riedell Powerdyle know that this SLF thread will continue being updated regularly until fair resolution of your problem has been implemented by them.

Rollin' on AIR

Last edited by Armadillo; October 5th, 2016 at 05:44 AM.
Armadillo is offline   Reply With Quote