View Single Post
Old February 22nd, 2019, 09:53 PM   #3
nickajshelden
Blades
 
nickajshelden's Avatar
 
Join Date: May 2016
Location: Tacoma, WA
Posts: 93
Default

ok, so I have a prototype installed, and it is surprisingly close to what I was looking for. I need to move the holes for the trinity mount on the toe a little closer together, I should probably thin the plate down by a millimeter or two, and lower the heel, but otherwise, it seems to do the job. I just stuck it together for these photos and did not tighten anything down.



__________________
-Pax
When the going gets tough, the tough get going; the smart left a long time ago.
nickajshelden is offline   Reply With Quote