Thread: Plate mount
View Single Post
Old December 6th, 2019, 12:29 AM   #2
Senior Member
fierocious1's Avatar
Join Date: Apr 2010
Location: Texas
Posts: 6,506

Originally Posted by polishedball View Post
Any opnions on if this is the correct way to mount the Avenger plate?

Going to swap out my probes with these but am trying to figure out the best way to center it and also determine front to back position. Any input thoughts appreciated Thanks
It depends.... on preferences, long plate-short plate, centered, forward, rear mount. Lots of combinations. I prefer a long mount. If your axle centerlines are about the same and you like it, I would set it up just the same. A little cushion swapping and you will be good to go.
Dims = psycho baby killers, failed(3 years) to get fakepeachment,fake reality and you're a racist!
fierocious1 is offline   Reply With Quote