View Single Post
Old August 13th, 2019, 12:20 PM   #5
Senior Member
fierocious1's Avatar
Join Date: Apr 2010
Location: Texas
Posts: 6,474

You may have to put it on an angle plate, center it and drill it out in a milling machine(tighter tolerances by using the mill will ensure dead center drilling). Then attempt to retap the original threads. Aluminum galls easily, basically welds itselft together. If it won't come out using a good table vise and a pipe wrench(destroying the toe stop) you really have no other choice.
Dims = promoting and carrying out baby deaths. Collusion, whistleblower, fakepeachment,fake reality and you're a racist!
fierocious1 is offline   Reply With Quote